Monthly Archives: September 2016

Using 2 PIR sensors on 1 GPIO Port

I have an issue in my kitchen where the PIR, although optimally placed, is still too far to detect the small movements we make when we eat at the table.

I wanted to add another PIR close to the table, but I didn’t want to use another GPIO port on the Raspberry Pi when all I needed was another sensor for the same overall status: movement in the kitchen or not, (regardless of which sensor picks it up).

So what I’m after is a logical OR gate: if PIR1 OR PIR2 is on, then the status is on, otherwise it’s off.

The answer is actually quite simple and only requires 3 components: 2 diodes and a resistor:

OR Diode Logic Gate

OR Diode Logic Gate

  • Connect [3] to the output of PIR1
  • Connect [4] to the output of PIR2
  • Connect [1] to the GPIO port on the Raspberry Pi

Et voila! 2 PIRs for improved motion coverage, but only 1 GPIO port used 😎